Vanagon EuroVan
Previous messageNext messagePrevious in topicNext in topicPrevious by same authorNext by same authorPrevious page (May 1997)Back to main VANAGON pageJoin or leave VANAGON (or change settings)ReplyPost a new messageSearchProportional fontNon-proportional font
Date:         Wed, 21 May 1997 23:05:52 -0700
Sender:       Vanagon Mailing List <vanagon@vanagon.com>
From:         Rick Gordon <rickgo@halcyon.com>
Subject:      

>> > How easy is it to remove that type awning? I've talked with some >folks who lugged their awning around with them all summer because putting >it on and taking it off was such a hassle. (I don't recall what kind it >was.) In a perfect world, I'd only want to have the awning attached to the >side of the bus when I was going camping or picnicking. > Last summer I spotted a rolled-up awning from Carefree of Colorado >on the side of a Westy in a parking lot. I never got a chance to speak with >the owner or see it deployed. Anybody have experience with that variety? > > Also, what kind of money are we looking at for either the A&E >(sounds like a cable TV channel) or Carefree awnings? >

I have one made by "Carefree of Colorado" on the EV. It's in a carrier that bolts using large metal plates onto the side of the van. For this, I let the dealer install it - we're talking 2-3 major holes per each plate!

It works pretty well, and is possible for one person to setup although two people make it a lot easier. (I'm also 6'4" and have a pretty good reach so consider this when I say "one person")

It's a bit tricky the first time you set it up. You end up with two frames with perpendicular (X-Y-Z) axes. The X axes join to each other, the Y axes hit the ground, the Z axes connect back onto the bracket mounts. The result is a nice aluminum rectangle holding the fabric taut, with aluminum posts of adjustable height. There are holes to pin down the posts with stakes but I've never needed to.

It's really nice in hot & wet weather - but if its wet you occasionally have to knock the water off.

Also you have to remember that it's made of aluminum - a soft metal and if you force it bending will occur. (And in case you didn't know, aluminum has no fatigue limit - bend it very far and it will break.) (My wife started to bend it before I stopped her during one of the initial setups!)

Cost is not pleasant. Frankly I don't remember exactly, but I think US$400+- was in the ballpark.

Pictures of the deployed awning are on my web page: start at http://www.halcyon.com/rickgo/ and follow the EuroVan links.

-rick

Rick Gordon Bainbridge Island, WA, USA ------------------------------------- rickgo@halcyon.com http://www.halcyon.com/rickgo/ KC7QEG finger for PGP public key fingerprint -------------------------------------


Back to: Top of message | Previous page | Main VANAGON page

Please note - During the past 17 years of operation, several gigabytes of Vanagon mail messages have been archived. Searching the entire collection will take up to five minutes to complete. Please be patient!


Return to the archives @ gerry.vanagon.com


The vanagon mailing list archives are copyright (c) 1994-2011, and may not be reproduced without the express written permission of the list administrators. Posting messages to this mailing list grants a license to the mailing list administrators to reproduce the message in a compilation, either printed or electronic. All compilations will be not-for-profit, with any excess proceeds going to the Vanagon mailing list.

Any profits from list compilations go exclusively towards the management and operation of the Vanagon mailing list and vanagon mailing list web site.