Vanagon EuroVan
Previous messageNext messagePrevious in topicNext in topicPrevious by same authorNext by same authorPrevious page (May 1997)Back to main VANAGON pageJoin or leave VANAGON (or change settings)ReplyPost a new messageSearchProportional fontNon-proportional font
Date:         Thu, 22 May 1997 06:44:40 -0400
Sender:       Vanagon Mailing List <vanagon@vanagon.com>
From:         kelphoto@mail.bright.net (mark keller)
Subject:      Re: High Idle on 87

>Date: Thu, 22 May 1997 06:44:13 -0400 >To:dfilcoff@stlnet.com >From:kelphoto@bright.net (mark keller) >Subject:Re: High Idle on 87 > >>High Idle on 87 2.1 l Digifant >>I did some more trouble shooting today. I checked the throttle return = >>spring, it works fine. I checked the vacuum lines, When I disconnected = >>the white or purple vacuum lines, the ones that come from the big = >>canister in the passenger side rear wheel well, nothing happened. Yes I = >>mean absolutely NOTHING. This would cause me to think that either the = >>lines were cracked or there is a problem with this canister. The lines = >>were not cracked and the connections are good. So what is this canister = >>what does it do, and how can I check it? > >The canister is a charcole purge canister that recyclies gas vapors from >the gas tank. This no vaccum source attachet to it. True they are vaccum >hoses, but they vent only. > >With the engine running, and all safety precautions taken, you could >attach of vaccuum gage to the motor right at the main vacuum source >nipple, use a plastic tee connector if you only have one place and it of >course has a hose on it. With the guage attached use a pair of needle >nose pliers to one by one momentarily crimp the major branchs of the >vacuum system near the source nipple. Watch the guage for "rise", a better >vacuum. If this occurs,follow that branch crimping after each split in >it's distrubution, watching each time for the "rise in vacuum pressure." > >If you have a vacuum leak in a hose,this method will quickly locate it. If >no improvement in vacuum pressure occurs, and your vacuum pressure is low, >at idle, 15 inches or less I believe, healthy is at 17-22 inches, then a >engine vacuum leak is a good possibilty. People spray a squirt of soapy >solution, or starting fluid at the intake manifold connetions, to either >see bubbles or a rise in the engine RPM. >> >>Dave >>87 GL Wolfsburg (120k) >>Dfilcoff@stlnet.com >>http://home.stlnet.com/~dfilcoff >


Back to: Top of message | Previous page | Main VANAGON page

Please note - During the past 17 years of operation, several gigabytes of Vanagon mail messages have been archived. Searching the entire collection will take up to five minutes to complete. Please be patient!


Return to the archives @ gerry.vanagon.com


The vanagon mailing list archives are copyright (c) 1994-2011, and may not be reproduced without the express written permission of the list administrators. Posting messages to this mailing list grants a license to the mailing list administrators to reproduce the message in a compilation, either printed or electronic. All compilations will be not-for-profit, with any excess proceeds going to the Vanagon mailing list.

Any profits from list compilations go exclusively towards the management and operation of the Vanagon mailing list and vanagon mailing list web site.