Date:         Sat, 10 May 1997 17:48:01 -0700
Sender:       Vanagon Mailing List <vanagon@vanagon.com>
From:         bayer@sybase.com (David Bayer)
Subject:      O-ring or gasket between heater core and valve?

Hello-
	I recently replaced the rear heater core in my 87 syncro. When I
separated the valve and the core, there was no gasket between the two, nor
was one included with the new core... I found that the gap between the two
leaks when pressed from the side (like when I tried to put cover for the
heater back on ;) ). Does anyone know if they is supposed to be an O-ring or
gasket? Any recommendations on some gasket goo that will seal and set
quickly? Thanks in advance...

dave

Please note - During the past 17 years of operation, several gigabytes of Vanagon mail messages have been archived. Searching the entire collection will take up to five minutes to complete. Please be patient!

Return to the archives @ gerry.vanagon.com

The vanagon mailing list archives are copyright (c) 1994-2011, and may not be reproduced without the express written permission of the list administrators. Posting messages to this mailing list grants a license to the mailing list administrators to reproduce the message in a compilation, either printed or electronic. All compilations will be not-for-profit, with any excess proceeds going to the Vanagon mailing list.

Any profits from list compilations go exclusively towards the management and operation of the Vanagon mailing list and vanagon mailing list web site.