My AC compressor (Sanden 508) leaks between the main body of the compressor and the end plate next to the pulley. Does anyone know if this where refrigerant finally works its way out after getting by the shaft seal? I know this sounds like a stupid question since the obvious place for the shaft seal to leak is next to the shaft but this is where the bubbles are. The VW parts film shows a set of gaskets for the valve body and end plate on the other (i.e. the hose end) of the compressor but there are no gaskets (except for the shaft seal kit) for the pulley end of the compressor even though there is a thin end plate on that end. If anyone has had any experience with a leaky shaft seal and has seen bubbles behind this end plate, let me know. By the way, this compressor (Sanden 508 with rear exit hoses for R-12, cat # 04508-VRA) is listed in the Vintage Air (San Antonio, Texas 1-800-862-6658) catalog for $199 (new). If anyone has any information about this leak, let me know. I need to decide if I can fix this with a shaft seal kit or if more involved repair is needed. Thanks, Ed McLean (mcleans@earthlink.net) '86 Westi
|
Please note - During the past 17 years of operation, several gigabytes of
Vanagon mail messages have been archived. Searching the entire collection
will take up to five minutes to complete. Please be patient!
Return to the archives @ gerry.vanagon.com
The vanagon mailing list archives are copyright (c) 1994-2011, and may not be reproduced without the express written permission of the list administrators. Posting messages to this mailing list grants a license to the mailing list administrators to reproduce the message in a compilation, either printed or electronic. All compilations will be not-for-profit, with any excess proceeds going to the Vanagon mailing list.
Any profits from list compilations go exclusively towards the management and operation of the Vanagon mailing list and vanagon mailing list web site.