To the list, Subject: Rear folding sofa/bed info. needed. I have resently purchased a rear sofa/bed, used, for my Syncro. As we were removing it, we noticed that the seat back pins were located in a different postion than the standard rear seat. It was easy to tell because the original pin holes were still located in the side interior panel, but had been plugged. After the removal of the side panels we found the mount for the pins were welded into place. It all looked as if it had been factory installed. Returning to my 2 Vanagons, an inspection of the same area showed that this welded bracket is NOT there. Does anyone have any insight to this? Is there an opional way to mount a sofa/bed? Thanks for any comments to this Joe Wagner vw4x4@fyi.net
|
Please note - During the past 17 years of operation, several gigabytes of
Vanagon mail messages have been archived. Searching the entire collection
will take up to five minutes to complete. Please be patient!
Return to the archives @ gerry.vanagon.com
The vanagon mailing list archives are copyright (c) 1994-2011, and may not be reproduced without the express written permission of the list administrators. Posting messages to this mailing list grants a license to the mailing list administrators to reproduce the message in a compilation, either printed or electronic. All compilations will be not-for-profit, with any excess proceeds going to the Vanagon mailing list.
Any profits from list compilations go exclusively towards the management and operation of the Vanagon mailing list and vanagon mailing list web site.