Harry Yates wrote: > snip > Removing the float assembly, and leaving it connected to the wiring > harness, I ran the float along the rod and the problem was > reproduced. Again, an intermittent problem. It would run through > the various levels correctly, and then sometimes stick on green. > I've played with the wires, and everything is tight, and clean. > snip Our '86 Sycro Westy (Canada specs) does not have a float mechanism (that I can find). Instead there are four (or is it three?) electrical contacts on the side (through from the outside) of the water tank. When the water level is such that two contacts are covered, the circuit is complete and the sensor light is lit. Larry
|
Please note - During the past 17 years of operation, several gigabytes of
Vanagon mail messages have been archived. Searching the entire collection
will take up to five minutes to complete. Please be patient!
Return to the archives @ gerry.vanagon.com
The vanagon mailing list archives are copyright (c) 1994-2011, and may not be reproduced without the express written permission of the list administrators. Posting messages to this mailing list grants a license to the mailing list administrators to reproduce the message in a compilation, either printed or electronic. All compilations will be not-for-profit, with any excess proceeds going to the Vanagon mailing list.
Any profits from list compilations go exclusively towards the management and operation of the Vanagon mailing list and vanagon mailing list web site.