Volks, On my 87 GL the following: 1) Washer pump completely silent when column switch pulled 2) 13.28 volts registering at the 2 pin jack to the washer pump when column switch activated 3) Washer pump works fabulously when jumpered directly to battery What gives? I suspect: 1) insufficient ground: could this cause this 2) insufficient amperage on pos side(I'm not sure this is easily measured: again, could this cause my symptoms The Bentley wiring diagram is very hard to decipher, any electron person with ideas, I welcome your thoughts. Regards Mark B. Magee 87GL 83K Kemah TX USA
|
Please note - During the past 17 years of operation, several gigabytes of
Vanagon mail messages have been archived. Searching the entire collection
will take up to five minutes to complete. Please be patient!
Return to the archives @ gerry.vanagon.com
The vanagon mailing list archives are copyright (c) 1994-2011, and may not be reproduced without the express written permission of the list administrators. Posting messages to this mailing list grants a license to the mailing list administrators to reproduce the message in a compilation, either printed or electronic. All compilations will be not-for-profit, with any excess proceeds going to the Vanagon mailing list.
Any profits from list compilations go exclusively towards the management and operation of the Vanagon mailing list and vanagon mailing list web site.