On Thu, 12 Jun 1997, Lon Herman wrote: > My Vanagon tranny has a bad input shaft, discovered when we pulled it to > replace the clutch. It is not really badly banged up, just enuf to cause > questions... (snip) > 1) does removal of the input shaft entail anything beyond removal of the > bellhousing, Yes > removal of the carrier bearings on either side of the shaft, the ring gear, > and then getting the snap ring loose? NO This procedure was suggested to me by > a transmission person in central Ohio I don't know too well. > He needs to find a new career! > 2) Will the input shaft from a later (water-cooled vanagon) tgransmission, > or earlier transmission from other vehicle work? > 3) I might be able to get the existing shaft tig welded, and then reground, > if I can do this cost-effectively.Any thoughts here? > I don't know what caused the shaft to get bunged up, but do worry a bit > about other bearings getting loose that might have caused this. A valid concern? It's really easy to put an input shaft in. Assuming it is similar to the 1986 and up. The bell housing comes off, there is a c-clip on the shaft next to a coupling, after you remove the clip, the spline coupler will slide on the shaft to allow the shaft to turn free from the trans input shaft. NO need to remove the rear end gears. your problem is finding what beat up the shaft!
|
Please note - During the past 17 years of operation, several gigabytes of
Vanagon mail messages have been archived. Searching the entire collection
will take up to five minutes to complete. Please be patient!
Return to the archives @ gerry.vanagon.com
The vanagon mailing list archives are copyright (c) 1994-2011, and may not be reproduced without the express written permission of the list administrators. Posting messages to this mailing list grants a license to the mailing list administrators to reproduce the message in a compilation, either printed or electronic. All compilations will be not-for-profit, with any excess proceeds going to the Vanagon mailing list.
Any profits from list compilations go exclusively towards the management and operation of the Vanagon mailing list and vanagon mailing list web site.