Hi, I'm about to replace the rear main oil seal on my '89 Vanagon - automatic. I don't relish the thought of dropping the trans, but it's better than the alternative... I have ordered an Oil Seal from Ron (thanks!) however, I notice an O-ring that is shown in the Bentley manual (section 13) on the page that shows the shim arrangement. I can't find the part number for this O-ring. Anyone got a clue? Also, any hints regarding dropping the trans would be great. Do I need the fancy seal installing tool? TIA, Bo Kersey Outdoor Technologies 511 West 41st Street Austin, TX 78751 (512)374-0500 voice (512)374-0200 fax
|
Please note - During the past 17 years of operation, several gigabytes of
Vanagon mail messages have been archived. Searching the entire collection
will take up to five minutes to complete. Please be patient!
Return to the archives @ gerry.vanagon.com
The vanagon mailing list archives are copyright (c) 1994-2011, and may not be reproduced without the express written permission of the list administrators. Posting messages to this mailing list grants a license to the mailing list administrators to reproduce the message in a compilation, either printed or electronic. All compilations will be not-for-profit, with any excess proceeds going to the Vanagon mailing list.
Any profits from list compilations go exclusively towards the management and operation of the Vanagon mailing list and vanagon mailing list web site.