Date:         Fri, 13 Jun 1997 18:20:59 -0700
Sender:       Vanagon Mailing List <vanagon@vanagon.com>
From:         "Mark A. Rokus" <marokus@voyager.net>
Subject:      Re: Input Shaft Woes

Another neat trick for removing the pilot bearing is to use a tap that
is just large enough to thread into the bearing and get some bite. Just
start threading until the pilot is pulled out.  (You could first thread
the bearing and then use a bolt if you are afraid of breaking the tap.)
Good luck
Mark

Please note - During the past 17 years of operation, several gigabytes of Vanagon mail messages have been archived. Searching the entire collection will take up to five minutes to complete. Please be patient!

Return to the archives @ gerry.vanagon.com

The vanagon mailing list archives are copyright (c) 1994-2011, and may not be reproduced without the express written permission of the list administrators. Posting messages to this mailing list grants a license to the mailing list administrators to reproduce the message in a compilation, either printed or electronic. All compilations will be not-for-profit, with any excess proceeds going to the Vanagon mailing list.

Any profits from list compilations go exclusively towards the management and operation of the Vanagon mailing list and vanagon mailing list web site.