This is only true if you do not have a the rubber bumper strip running the lenght of the bumper. The bumper strip makes it impossible to remove the bolts without damaging a number of the plastic clips that hold it on. The same goes for the front bumper again assuming that there is the two rubber strips along the lenght of the bumper Dan On Tue, 22 Jul 1997 JordanVw@aol.com wrote: > In a message dated 97-07-22 13:53:20 EDT, danmoy@HOME.CYNET.NET (Dan Moy) > writes: > > << Then remove the 4 bolts holding the bumper brackets from > inside the rear fender wells. > >> > > you can just unbolt the blade from the brackets (4 13?mm bolts) > FAR easier than removing the brackets.... > > chris >
|
Please note - During the past 17 years of operation, several gigabytes of
Vanagon mail messages have been archived. Searching the entire collection
will take up to five minutes to complete. Please be patient!
Return to the archives @ gerry.vanagon.com
The vanagon mailing list archives are copyright (c) 1994-2011, and may not be reproduced without the express written permission of the list administrators. Posting messages to this mailing list grants a license to the mailing list administrators to reproduce the message in a compilation, either printed or electronic. All compilations will be not-for-profit, with any excess proceeds going to the Vanagon mailing list.
Any profits from list compilations go exclusively towards the management and operation of the Vanagon mailing list and vanagon mailing list web site.