I found the same problem of a stripped out drain plug in my 86 when I bought it. I tapped it out to the thread size of the pressure relief valve of a type one engine. I used the plug from a type one because it is machined to be used with a metal sealing washer that will fit nicely and seal on the shoulder that is left. You will have to use a large screwdriver to change the oil though. Peg Piwonka wrote: > > I didn't do it!!! > > Imagin my surprise when I went under my "new" 84 Westfalia to change > the oil and found a one inch bolt sticking out of the oil plug area. a wing > nut device ther was holding a rubber stopper in place. This thing holds the > life blood of the engine in. I wiggled it and it fel off in my hand! My > oil pan was already there but what if this had happened on the road!!! > I replaced the rubber stopper and it seems to be holding. I ordered > a new bolt from the dealer but I suspect that the inner threads may be > stripped. I'll try a new bolt but then what? I have a good shadetree > mechanic near buy but what is the best fix for this? Help. > > Eric
-- Todd Francis '86 Westy Syncro '91 Tristar
|
Please note - During the past 17 years of operation, several gigabytes of
Vanagon mail messages have been archived. Searching the entire collection
will take up to five minutes to complete. Please be patient!
Return to the archives @ gerry.vanagon.com
The vanagon mailing list archives are copyright (c) 1994-2011, and may not be reproduced without the express written permission of the list administrators. Posting messages to this mailing list grants a license to the mailing list administrators to reproduce the message in a compilation, either printed or electronic. All compilations will be not-for-profit, with any excess proceeds going to the Vanagon mailing list.
Any profits from list compilations go exclusively towards the management and operation of the Vanagon mailing list and vanagon mailing list web site.