Date: Tue, 22 Jul 1997 20:41:50 CDT
Sender: Vanagon Mailing List <vanagon@vanagon.com>
From: Joel Walker <JWALKER@UA1VM.UA.EDU>
Subject: Re: fuel line size
On Tue, 22 Jul 1997 09:48:15 -0600 you said:
>1 - the archives say to buy 8mm(5/16") hose.
>I know my fuel filter takes 7mm hose.
>How much of each?
on my 88 bus, the sizes were 7 (or 8) mm for the vast majority of the hoses.
i bought 25 feet. used about half of it. but i did have to redo one hose that
i cut too short ... do one hose at a time and make the new hose about one
inch longer than the old one. :)
the only hose that was different was the 10mm from the tank to the fuel
pump. i got three feet of it, and used only about 18" of it.
>2 - I also need to replace one of the Y fittings on top of my tank.
>I am thinking about replacing all the hose up there too while i'm at it.
>Is this a good idea?
>Do I need clamps for this hose?
>What size hose do I use for this?
i did ... replace all the engine hoses, that is. :) i thought it was a
good idea. but be careful!! that "ring" of hoses around to the fuel injectors
and back to that "Y" has a lot of pressure. so be prepared for spraying fuel.
yes, get clamps. and it was the 7 (or 8) mm hose again.
>3 - am I in for hell while doing this??
well ... no. not unless you make a spark or someone comes in with a lit
cigarette. :) it's tedious and slow, but not "hard". just take it slow
and easy, one hose at a time. and mop of the gasoline. and make DAMNED
sure you get ALL the rags away from the engine BEFORE you try to crank the
engine!!! :) and be SURE to check ALL the clamps while the car is running
... and shut it off quick if you see a leak.
it took me about three hours of piddling, looking, fiddling, and doing the
replacement. the hardest ones to get to are the just-outside-the-engine-
compartment, behind the rear wheels. they are WAAAAAY up high and just almost
out of arm's reach from the ground. but go slow, and you can do it.
have a fire extinguisher handy.
good luck.
joel