The metal sealing rings commonly stick to the inside of the heads - look like a thin raised ring around the top of the bore. If so, and you try to unstick it be careful not to scratch the head surface. The thin rubber ring fits in a small groove on the outside of the cylinder. After lots of miles this is often full of crud and not visible. Use a small pointed scraper and you'll find the groove and can clean it out. The Oring will not come out in one piece - it's silicone and very weak - and if the engine's ever lost coolant and overheated - may not be much left. Don't use a sharp tool when you clean the groove or the scratches may prevent sealing if you are re-using the cylinders. Use only the "real" o-rings for this top seal - normal non-silicone won't take the heat. (Silicone is good for high temp, water and gasses - poor for oil, so it's used only for this top end.) Now if you can get the piston pins out without the special reamer you are one up on me. Once the coolant is out removing the engine is pretty easy - good time for a clutch kit too, and the hoses on an '87 may be questionable. Tom Brunson
>I just pulled the heads off of my '87, much to my surprise the upper rubber and >metal sealing rings that my Bentley manual shows were not there! Is this >possible? Do I have the wrong picture of how these go together? At bottom of >cylinder, there is supposed to be another o-ring. At the top of the cylinder a >very thin o-ring and a metal sealing gasket. >I still have the case in the van, I am wondering if I should take it out and see >what else is 'right'. Any input appreciated. >Regards, >Joe Fahy
|
Please note - During the past 17 years of operation, several gigabytes of
Vanagon mail messages have been archived. Searching the entire collection
will take up to five minutes to complete. Please be patient!
Return to the archives @ gerry.vanagon.com
The vanagon mailing list archives are copyright (c) 1994-2011, and may not be reproduced without the express written permission of the list administrators. Posting messages to this mailing list grants a license to the mailing list administrators to reproduce the message in a compilation, either printed or electronic. All compilations will be not-for-profit, with any excess proceeds going to the Vanagon mailing list.
Any profits from list compilations go exclusively towards the management and operation of the Vanagon mailing list and vanagon mailing list web site.