TBill If you disconnect the idle switch the F.I. unit will never know when the throttle is closed, so it will dump in excess fuel when decelerating (less engine braking, certainly wasting gas and increasing emissions), and the idle stabilization won't work properly - so loading the engine (A/C, electrical loads, etc) will affect the idle speed. The F.I. system responds to this switch both when decelerating (cuts out fuel injectors) and when coming off idle. The switch has to function at the correct "off idle" position or (according to Bentley): if the gap is too large (switch acts too late) the engine will surge when coming off idle (The FI unit doesn't react until the throttle is too far open - then it will respond to the open throttle and jump to the higher RPM - skipping the lower RPM positions) - this sounds like your situation if the gap is too small (switch acts too soon) the engine will tend to cut out or stall coming off idle. The Digijet (83-85) also has a full-throttle switch, and these models adjust differently than the Digifant (86-91) which only have the idle switch. For the Digijet there is a small adjustment screw on the throttle arm that triggers the switch. Bentley says to adjust by first closing the throttle; then adjust the screw until the switch JUST closes; then turn the screw exactly one turn farther IN and seal it in position (nail polish?) The Digifant switch is adjusted by a cam and feeler gauge. This does affect the behavior starting from idle a lot - and the car will react better when it is set properly. Tom Brunson Austin
Craig Rogers wrote: > > Sounds like it could be the idle portion of the switch that you are talking > about. If that sticks and stays closed when the throttle is opened, the > engine will seem to hunt until it reaches a point where the deceleration > fuel shut-off is bypassed at around 2500 RPM. Try adjusting it. Bentley > covers it. That sounds right,altho it ends up near 3000 rpm. Adjust? What's to adjust? It seems to work normally, makes a little click, but evidently the circut stays open (or is it closed?) Anyway, just yanked one of the wires on back and it runs fine. I don't have a Bently, hence all the questions,ie, WHAT IS IT? And do I need it? What for? TBill
|
Please note - During the past 17 years of operation, several gigabytes of
Vanagon mail messages have been archived. Searching the entire collection
will take up to five minutes to complete. Please be patient!
Return to the archives @ gerry.vanagon.com
The vanagon mailing list archives are copyright (c) 1994-2011, and may not be reproduced without the express written permission of the list administrators. Posting messages to this mailing list grants a license to the mailing list administrators to reproduce the message in a compilation, either printed or electronic. All compilations will be not-for-profit, with any excess proceeds going to the Vanagon mailing list.
Any profits from list compilations go exclusively towards the management and operation of the Vanagon mailing list and vanagon mailing list web site.