Remember, on a 4-cycle engine the distributor rotates once for each TWO rotations of the crankshaft. When aligned with the notch #1 cyl is a TDC with valves CLOSED; with the dist. 180 deg away #1 is at TDC with valves OPEN. Rotate the crank 1 turn and the distributor will line up like the manual says. Tom SNIP On reinstalling, forgot to seat it properly. Isn't the contact on the rotor supposed to line up with the notch on the edge of the distributor housing, when you're around top-dead center? Mine is now 180 degrees off. SNIP
|
Please note - During the past 17 years of operation, several gigabytes of
Vanagon mail messages have been archived. Searching the entire collection
will take up to five minutes to complete. Please be patient!
Return to the archives @ gerry.vanagon.com
The vanagon mailing list archives are copyright (c) 1994-2011, and may not be reproduced without the express written permission of the list administrators. Posting messages to this mailing list grants a license to the mailing list administrators to reproduce the message in a compilation, either printed or electronic. All compilations will be not-for-profit, with any excess proceeds going to the Vanagon mailing list.
Any profits from list compilations go exclusively towards the management and operation of the Vanagon mailing list and vanagon mailing list web site.