Date:         Sat, 23 Aug 1997 19:16:48 -0400
Sender:       Vanagon Mailing List <vanagon@vanagon.com>
From:         David Katsuki <katsuki@BBN.COM>
Subject:      Re: 88 Vanagon air flow meter question

Mine is glued on too - Needed to be carefully pried off.    After I
repositioned the wiper arm, I just reglued it with silicone.

Dave

At 11:55 PM 8/22/97 -0400, John Graham wrote:
>I think that the cause of some early morning hesitation and stalling at
>idle may be due to the age and condition of my air flow control box.  I had
>a 1980 model with a similar box and the black plastic cover on top, would
>just pop off.  Mine appears to be glued on.  Does this indicate work by the
>PO or the PO's repair shop?  Should that black plastic cover be removable
>so that I can check out the resistor and wiper arm that hide inside?
>
>John Graham
>'88 Westy
>Charlotte NC
>
>

Please note - During the past 17 years of operation, several gigabytes of Vanagon mail messages have been archived. Searching the entire collection will take up to five minutes to complete. Please be patient!

Return to the archives @ gerry.vanagon.com

The vanagon mailing list archives are copyright (c) 1994-2011, and may not be reproduced without the express written permission of the list administrators. Posting messages to this mailing list grants a license to the mailing list administrators to reproduce the message in a compilation, either printed or electronic. All compilations will be not-for-profit, with any excess proceeds going to the Vanagon mailing list.

Any profits from list compilations go exclusively towards the management and operation of the Vanagon mailing list and vanagon mailing list web site.