I noticed some discussion about the replacement pop-top gasket available from the Bus Depot. (These are the one with aluminum internal clamps rather than the factory steel (i.e. rust prone) ones.) It is true that the replacement seal is not as tall as the factory one. I've only put the front on on so far, but have noticed that because the seal is not as tall as the factory one, it does not fit snug against the roof of the van. There is probably a 1/16" air gap at some places. While I was initially concerned about this, I've noticed no adverse effect. It is not noticiable unless you get within a few inches of the seal. I do really like the idea of having a seal that will nut rust and put ugly orange stripes down the side of the van though! Todd '88 Westfalia |
Please note - During the past 17 years of operation, several gigabytes of
Vanagon mail messages have been archived. Searching the entire collection
will take up to five minutes to complete. Please be patient!
Return to the archives @ gerry.vanagon.com
The vanagon mailing list archives are copyright (c) 1994-2011, and may not be reproduced without the express written permission of the list administrators. Posting messages to this mailing list grants a license to the mailing list administrators to reproduce the message in a compilation, either printed or electronic. All compilations will be not-for-profit, with any excess proceeds going to the Vanagon mailing list.
Any profits from list compilations go exclusively towards the management and operation of the Vanagon mailing list and vanagon mailing list web site.