There really isn't much to it. On mine I was able to get access from the hole in the top where the ash tray goes. I don't know how that may have changed over the years. I just pushed the radio as far in as it would go and looked to see where it was hitting, and then heated with a heat gun and pushed the plastic back with a piece of wood and held it until it cooled. I used the wood rather than the radio because I wanted to have a little bit of clearance behind it when it was installed. I also put a piece of foam under the radio to cushion it from bumps. It seems to work OK for this, but I wish it were better. Just remember that the blower is inside the housing that you are moving and you could conceivably push the housing into the blower and cause it to rub, so you should turn the blower on while you are holding it in place to make sure it isn't hitting. You could also conceivably poke or melt a hole in the plastic and this would cause a problem, so these are the only things that I can think of to avoid. Good luck. Craig Rogers Ineffable Audio Unity Inc. The song of Life envelops the timeless void. Its name is...IAU Specializing in Uher tape recorders (914) 378-1606, carogers@idt.net -----Original Message----- From: Todd Last [SMTP:Rubatoguy@ibm.net] Sent: Sunday, September 21, 1997 3:33 AM To: Craig Rogers Subject: Re: Radio Questions At 07:06 PM 9/20/97 -0400, you wrote: >The problem with the limited depth of the radio area in the dash of the Vanagon is due to the housing of the heater blower. If you use a heat gun to heat the plastic housing behind the radio, you can push it back and out of the way. The whole in the dash is standard DIN, so basically any standard radio will fit. >Regarding brands of equipment, I'm partial to Becker radios (when I'm not listening to my Uher reel to reel) and Focal Speakers. > >Sincerely, >Craig Rogers '85 Wolfsburg Weekender >Ineffable Audio Unity Inc. >The song of Life envelops the timeless void. > Its name is...IAU >Specializing in Uher tape recorders. >(914) 378-1606, carogers@idt.net Hey, GREAT tip!!!! Thanks. I think I may try this, any tricks to using the heatgun on the heater housing? |
Please note - During the past 17 years of operation, several gigabytes of
Vanagon mail messages have been archived. Searching the entire collection
will take up to five minutes to complete. Please be patient!
Return to the archives @ gerry.vanagon.com
The vanagon mailing list archives are copyright (c) 1994-2011, and may not be reproduced without the express written permission of the list administrators. Posting messages to this mailing list grants a license to the mailing list administrators to reproduce the message in a compilation, either printed or electronic. All compilations will be not-for-profit, with any excess proceeds going to the Vanagon mailing list.
Any profits from list compilations go exclusively towards the management and operation of the Vanagon mailing list and vanagon mailing list web site.