Vanagon EuroVan
Previous messageNext messagePrevious in topicNext in topicPrevious by same authorNext by same authorPrevious page (September 1997)Back to main VANAGON pageJoin or leave VANAGON (or change settings)ReplyPost a new messageSearchProportional fontNon-proportional font
Date:         Fri, 5 Sep 1997 12:21:36 -0700
Reply-To:     Tobin Copley <tcopley@POP.UNIXG.UBC.CA>
Sender:       Vanagon mailing list <Vanagon@Gerry.SDSC.EDU>
From:         Tobin Copley <tcopley@POP.UNIXG.UBC.CA>
Subject:      Re: Yokohama Y370s & tire pressure [was: Got em! Itchigo's
              wearing...]
Comments: To: David Raistrick <xi8940@freenet.tlh.fl.us>,
          Aircooled Type ii's <type2@bigkitty.azaccess.com>
In-Reply-To:  <199709050111.SAA32226@bigkitty.azaccess.com>
Content-Type: text/plain; charset="us-ascii"

At 6:11 PM -0700 9/4/97, David Raistrick wrote:

>You folks running [Yokohama Y] 370's (or similiar load D tires) on a >Baywindow >Westy (non-westy's too..) What inflation pressures have you >found success with?

I LOVE the Yoko Y370s I had on our 1976 Westy (Mango Camper). Thousands and thousands of miles of unpaved road / off-road driving and not a single flat. Strong sidewalls make it good for cornering and in crosswinds, and has sufficiently aggressive tread to bite on loose / slippery surfaces, yet fairly quiet on pavement.

The pressure I run depends on road surface and condition. For highway cruising we ran about 40 - 45 lbs, lower in bad wet or snow. Off pavement we generally knocked it down to 30 lbs or so, and below 20 for very loose (and slow) surfaces.

There are two schools of thought for travel on unpaved surfaces covered in sharp fragments (like shale chip road beds or blasted & bulldozed road cuts). One is to air down so that the tire will give and bend around a sharp object; the other is to put the pressure up so that sharp things are shot away from the tire. For example, on the Dempster Highway to Inuvik, which is paved largely in shale fragments the size and shape of arrowheads, I boosted the pressure to the maximum rating for the tires: 65 lbs. No flats.

Sometimes I wonder if the steel wheel itself is (a) designed for, and (b) can safely handle, tire pressures that high. The wheels were built with the expectation that Michelin XZXs (40 lbs max?) would be mounted on them. Thoughts?

Tobin 1976 Westy ex-owner (now owned by Seattle listmember Peter Small) 1997 son Russell (wanna westy! wahhh!)

---------------------------------------------------------------------------- Tobin T. Copley,MA Research Associate tobin.copley@ubc.ca Offshore office: Bowen Island, B.C. UBC (M,T,W):(604) 822-6219 B.C. Centre for Excellence in HIV/AIDS Bowen Island (R,F):(604) 947-2642 Dept. of Health Care & Epidemiology St. Paul's Hospital:(604) 631-5753 University of British Columbia http://cfeweb.hivnet.ubc.ca/chrp/


Back to: Top of message | Previous page | Main VANAGON page

Please note - During the past 17 years of operation, several gigabytes of Vanagon mail messages have been archived. Searching the entire collection will take up to five minutes to complete. Please be patient!


Return to the archives @ gerry.vanagon.com


The vanagon mailing list archives are copyright (c) 1994-2011, and may not be reproduced without the express written permission of the list administrators. Posting messages to this mailing list grants a license to the mailing list administrators to reproduce the message in a compilation, either printed or electronic. All compilations will be not-for-profit, with any excess proceeds going to the Vanagon mailing list.

Any profits from list compilations go exclusively towards the management and operation of the Vanagon mailing list and vanagon mailing list web site.