I have tried to find the appropriate directions to do this in Bentley but have been unsuccessful. How does one go about removing the side panel trims (the PO had attached a couple of brackets to the trim panel using stove bolts and nuts which I want to remove)? Bentley seems to hint that the rear headliner should be removed first, but I don't know if this is necessary. On a related issue, will this give me access to the rear light markers from the inside. I have a problem in that the passenger side the plastic tabs into which the marker is screwed into, are spinning in place. I haven't successfully been able to get the marker off to replace the burnt out bulb. (And yes I have done this on the driver's side so that I know that you have to pull at the marker to maintain pressure on the plastic tab as you are unscrewing ;-)). I'd be most grateful if someone who is familiar with the procedure could walk me through the steps. advTHANKSance. Cheers, - pavneet .......................................................................... pavneet@cyantic.com -------------------------- Cyantic Systems Corporation |
Please note - During the past 17 years of operation, several gigabytes of
Vanagon mail messages have been archived. Searching the entire collection
will take up to five minutes to complete. Please be patient!
Return to the archives @ gerry.vanagon.com
The vanagon mailing list archives are copyright (c) 1994-2011, and may not be reproduced without the express written permission of the list administrators. Posting messages to this mailing list grants a license to the mailing list administrators to reproduce the message in a compilation, either printed or electronic. All compilations will be not-for-profit, with any excess proceeds going to the Vanagon mailing list.
Any profits from list compilations go exclusively towards the management and operation of the Vanagon mailing list and vanagon mailing list web site.