>| I made an insert for the driver's window the length of the window and >| about 6" >| wide out of 2" thick styrofoam (heavy duty) and formica (sandwiching the >| styrofoam) for the exhaust vent. I drilled a hole in it and permanently >| attached the exterior vent contraption (kind of like the one for the >| refridgerator) to the insert. When I use the heater, i just lower the >| driver's >| side window, insert the insert and close the window on it to make a >| tight >| seal. then i connect the vent hose from the heater to the exhaust port >| on the >| insert. I believe such an exhaust scheme could be used with the propex in the short term as well. Maybe two temp inserts would be needed to handle both intake and exhaust - one for driver's window and one for rear opening window behind the driver's seat... dave |
Please note - During the past 17 years of operation, several gigabytes of
Vanagon mail messages have been archived. Searching the entire collection
will take up to five minutes to complete. Please be patient!
Return to the archives @ gerry.vanagon.com
The vanagon mailing list archives are copyright (c) 1994-2011, and may not be reproduced without the express written permission of the list administrators. Posting messages to this mailing list grants a license to the mailing list administrators to reproduce the message in a compilation, either printed or electronic. All compilations will be not-for-profit, with any excess proceeds going to the Vanagon mailing list.
Any profits from list compilations go exclusively towards the management and operation of the Vanagon mailing list and vanagon mailing list web site.