Vanagon EuroVan
Previous messageNext messagePrevious in topicNext in topicPrevious by same authorNext by same authorPrevious page (October 1997)Back to main VANAGON pageJoin or leave VANAGON (or change settings)ReplyPost a new messageSearchProportional fontNon-proportional font
Date:         Thu, 2 Oct 1997 23:50:10 -0400
Reply-To:     Joe Wagner <vw4x4@FYI.NET>
Sender:       Vanagon mailing list <Vanagon@Gerry.SDSC.EDU>
From:         Joe Wagner <vw4x4@FYI.NET>
Subject:      Re: CV Joint Frustrations
Comments: To: Lawrence Johnson <ljohnson@HALHINET.ON.CA>
In-Reply-To:  <34341E58.791B05A1@halhinet.on.ca>
Content-Type: TEXT/PLAIN; charset=US-ASCII

Use a punch in the hole in the center of the shaft only. If you try to use a sock or such on the end chances are you can mushroom the end enough to end up cutting it off. If you have already done damage find a press.

Eric - Pgh. PA USA 86-VW4x4 * 72-240z * 1936-Chrysler

On Thu, 2 Oct 1997, Lawrence Johnson wrote:

> Listees, > I'm trying to replace two of the CV joints and four of the boots on the > rear axle of my '86 Syncro Westfalia. > How do I separate the CV joint from the shaft? I have removed the > circlip and tried both methods of separation: 1) used a drift and hammer > on the inner part of the CV joint to drive it off of the shaft and 2) > used a drift and hammer to drive the shaft through the CV joint. I got > 1/16 inch movement and then nothing more. Should I just persist and > swear louder? Should I find a hydraulic press? What am I doing wrong? > Did I miss something? > > I'm frustrated and about to give up on this CV joint project. Larry :-( >


Back to: Top of message | Previous page | Main VANAGON page

Please note - During the past 17 years of operation, several gigabytes of Vanagon mail messages have been archived. Searching the entire collection will take up to five minutes to complete. Please be patient!


Return to the archives @ gerry.vanagon.com


The vanagon mailing list archives are copyright (c) 1994-2011, and may not be reproduced without the express written permission of the list administrators. Posting messages to this mailing list grants a license to the mailing list administrators to reproduce the message in a compilation, either printed or electronic. All compilations will be not-for-profit, with any excess proceeds going to the Vanagon mailing list.

Any profits from list compilations go exclusively towards the management and operation of the Vanagon mailing list and vanagon mailing list web site.