Vanagon EuroVan
Previous messageNext messagePrevious in topicNext in topicPrevious by same authorNext by same authorPrevious page (October 1997)Back to main VANAGON pageJoin or leave VANAGON (or change settings)ReplyPost a new messageSearchProportional fontNon-proportional font
Date:         Wed, 22 Oct 1997 09:10:26 -0700
Reply-To:     Tom Young <young@SHERLOCK.SIMS.BERKELEY.EDU>
Sender:       Vanagon mailing list <Vanagon@Gerry.SDSC.EDU>
From:         Tom Young <young@SHERLOCK.SIMS.BERKELEY.EDU>
Subject:      Re: 83 Vanagon stalling UPDATE
Comments: To: falsone_jesse@ADVMAR.COM
In-Reply-To:  <00000252.@advmar.com>
Content-Type: TEXT/PLAIN; charset=US-ASCII

On Wed, 22 Oct 1997 falsone_jesse@ADVMAR.COM wrote:

> Here is an update on my stalling problems with my 1983 Vanagon (air-cooled, > non-calif) > > Note - 80-83 air cooled, non-california Vanagons don't have an O2 sensor > to the best of my knowledge (sources include owners manual and Bentley > exhaust schematic)

That's correct.

> The tentative conclusion I have reached is that the fuel pressure regulator is > defective.

In my case, when my fuel pressure regulator failed I was running LEAN as my fuel pressure was too low. For about $14 you can make a perfectly good fuel pressure gauge (see archives or email me) and test the FPR directly instead of shelling out ~$60.

> Before ordering this part, I plan to check the #2 Temp sensor (suggested by > Darrell Boehler)

Yes, and the #1 temp sensor at the same time.

> and the idle position switch (calif only?) (suggested by Ken > Lewis).

My Cal '81 sure doesn't have one.

> 2) Is there a way to adjust the CO without a CO meter?

The "Bosch Fuel Injection and Engine Management" book says "... adjust the mixture for the leanest setting that provides a smooth idle, then enrich the mixture an additional 1/4 turn. Test drive and check for surging at part throttle, if so, enrich 1/4 turn at a time until the surging disappears."

> I don't have a cat converter (removed by PO), so I'm guessing I'm already > running very high. Which way do you turn the screw to make it lean?

Clockwise. You might be running too high for smog without a catalytic converter, but that doesn't mean you're running too high for the basic mixture adjustment. The best bet is to use a CO meter.

--------------------------------------------------------------------- Tom Young young@sherlock.SIMS.Berkeley.EDU Lafayette, CA 94549 '81 Vanagon ---------------------------------------------------------------------


Back to: Top of message | Previous page | Main VANAGON page

Please note - During the past 17 years of operation, several gigabytes of Vanagon mail messages have been archived. Searching the entire collection will take up to five minutes to complete. Please be patient!


Return to the archives @ gerry.vanagon.com


The vanagon mailing list archives are copyright (c) 1994-2011, and may not be reproduced without the express written permission of the list administrators. Posting messages to this mailing list grants a license to the mailing list administrators to reproduce the message in a compilation, either printed or electronic. All compilations will be not-for-profit, with any excess proceeds going to the Vanagon mailing list.

Any profits from list compilations go exclusively towards the management and operation of the Vanagon mailing list and vanagon mailing list web site.