Vanagon EuroVan
Previous messageNext messagePrevious in topicNext in topicPrevious by same authorNext by same authorPrevious page (October 1997)Back to main VANAGON pageJoin or leave VANAGON (or change settings)ReplyPost a new messageSearchProportional fontNon-proportional font
Date:         Wed, 22 Oct 1997 19:00:03 -0400
Reply-To:     Dennis Haynes <dhaynes57@EMAIL.MSN.COM>
Sender:       Vanagon mailing list <Vanagon@Gerry.SDSC.EDU>
From:         Dennis Haynes <dhaynes57@EMAIL.MSN.COM>
Subject:      Re: Removing Syncro front axles
Comments: To: Eric Zeno <vw4x4@FYI.NET>

No! The outer CV joints actually hold the bearing together. You can use an old joint in its place if really needed.

Dennis -----Original Message----- From: Eric Zeno <vw4x4@FYI.NET> To: Vanagon@GERRY.SDSC.EDU <Vanagon@GERRY.SDSC.EDU> Date: Tuesday, October 21, 1997 1:18 PM Subject: Removing Syncro front axles

> Does anyone know if the Syncro can be run with out the > front axles. I need my Syncro to get to work and If > I get in a jam, I may just remove them until I can get > the parts. > > Eric 86-VW4x4 > vw4x4@fyi.net 72-240z > Pittsburgh, PA USA 1936-Chrysler >


Back to: Top of message | Previous page | Main VANAGON page

Please note - During the past 17 years of operation, several gigabytes of Vanagon mail messages have been archived. Searching the entire collection will take up to five minutes to complete. Please be patient!


Return to the archives @ gerry.vanagon.com


The vanagon mailing list archives are copyright (c) 1994-2011, and may not be reproduced without the express written permission of the list administrators. Posting messages to this mailing list grants a license to the mailing list administrators to reproduce the message in a compilation, either printed or electronic. All compilations will be not-for-profit, with any excess proceeds going to the Vanagon mailing list.

Any profits from list compilations go exclusively towards the management and operation of the Vanagon mailing list and vanagon mailing list web site.