Date:         Mon, 13 Oct 1997 09:28:24 -0700
Reply-To:     Mark McCulley <raven@HALCYON.COM>
Sender:       Vanagon mailing list <Vanagon@Gerry.SDSC.EDU>
From:         Mark McCulley <raven@HALCYON.COM>
Subject:      Propex installation question
Content-Type: text/plain; charset="us-ascii"

I'm installing my Propex heater (finally) under the rear seat and have some
questions about where to route the combustion inlet pipe. I'm routing the
outlet pipe to the edge of the passenger-side rear jack flange. The
instructions that came with the heater say to keep the inlet and outlet
openings 0.5 meters apart and that the openings should face the same direction.

Why do the openings need to face the same direction?

Where is a good place to put the inlet pipe opening?

Thanks,
Mark McCulley

Please note - During the past 17 years of operation, several gigabytes of Vanagon mail messages have been archived. Searching the entire collection will take up to five minutes to complete. Please be patient!

Return to the archives @ gerry.vanagon.com

The vanagon mailing list archives are copyright (c) 1994-2011, and may not be reproduced without the express written permission of the list administrators. Posting messages to this mailing list grants a license to the mailing list administrators to reproduce the message in a compilation, either printed or electronic. All compilations will be not-for-profit, with any excess proceeds going to the Vanagon mailing list.

Any profits from list compilations go exclusively towards the management and operation of the Vanagon mailing list and vanagon mailing list web site.