Date:         Mon, 20 Oct 1997 23:18:18 UT
Reply-To:     Tom Brunson <TABRUN@CLASSIC.MSN.COM>
Sender:       Vanagon mailing list <Vanagon@Gerry.SDSC.EDU>
From:         Tom Brunson <TABRUN@CLASSIC.MSN.COM>
Subject:      Re: WTB Knarly Spark Plug Wire Set
Comments: To: vwmaster@VOLKS-MOTORSPORTS.COM

Good wires in good shape shouldn't need to be kept spaced from each other -
although I commonly tie the "bundle" away from grounding points.

My '72 & '77 BMW 6 cyl engines (with aftermarket HEI) routed all plug wires in
a parallel bundle down a plastic tube with openings that split each wire out
at the plug where it connected. Never had an ignition problem between the
wires, although the coil wire went bad on both.

Between plug wires you have two thicknesses of insulation, and a "pinhole"
would have to develop between both to cause a problem.

Tom
Austin, TX

----------
From:   Vanagon mailing list on behalf of vwmaster@VOLKS-MOTORSPORTS.COM
Sent:   Monday, October 20, 1997 9:34 AM
To:     Vanagon@GERRY.SDSC.EDU
Subject:        Re: WTB Knarly Spark Plug Wire Set

Mark,

  On the Zip Tye deal, I use one Bigger tye then "Between" the wires I
run a small zip tye around the zip tye.  This insulates the wires from
each other but still lets them follow the same path.  I've used this on
many cars including a race car that I ran for 4 years.  This helps to
keep the wires from touching hot surfaces etc on other types of cars.

  On the wires, I have Bosch wires for your Vanagon for $65.00.

  I hope this info helps you?

  Kyle

--

  Kyle Wade  (408) 426-1431 OR  (408) 429-9424
  Keeper of the Volks-Motorsports page
  Home Page - http://www.volks-motorsports.com