Date: Thu, 11 Dec 1997 15:52:41 -0800
Reply-To: "L-Soft list server at Vanagon List (1.8c)"
<LISTSERV@GERRY.SDSC.EDU>
Sender: Vanagon Mailing List <Vanagon@Gerry.SDSC.EDU>
From: "L-Soft list server at Vanagon List (1.8c)"
<LISTSERV@GERRY.SDSC.EDU>
Subject: Re: engine swap (ignorant questions) -> EV piston slap
> STOP THIS !!!!!!!!!!!!!!!!!
You are not authorized to use the STOP command.
> L-Soft list server at Vanagon List (1.8c) wrote:
Unknown command - "L-SOFT". Try HELP.
>>
>> >> All Audi I-5 engines I've seen fitted to Audi 4K, 5K, 80, 90, 100, 200,
>>
>> > Unknown command - "ALL". Try HELP.
>> Unknown command - "UNKNOWN". Try HELP.
>>
>> >> and VW Quantum are canted at approx 15-20 degrees.
>>
>> > Unknown command - "AND". Try HELP.
>> Unknown command - "UNKNOWN". Try HELP.
>>
>> >> rb
>>
>> > Unknown command - "RB". Try HELP.
>> Unknown command - "UNKNOWN". Try HELP.
>>
>> >> ----------------------------
>>
>> > Unknown command - "----------------------------". Try HELP.
>> Unknown command - "UNKNOWN". Try HELP.
>>
>> >> Scot wrote:
>>
>> > Unknown command - "SCOT". Try HELP.
>> Unknown command - "UNKNOWN". Try HELP.
>>
>> >> I don't believe "Piston Slap" is HYPE, as it was claimed. I have a
>>
>> > Unknown command - "I". Try HELP.
>> Unknown command - "UNKNOWN". Try HELP.
>>
>> >> question about the angle of the inline 5 as it is used in the Audi; do
>>
>> > Unknown command - "QUESTION". Try HELP.
>> Unknown command - "UNKNOWN". Try HELP.
>>
>> >> the pistons travel vertically, or is there some angle set from
>>
>> > Unknown command - "THE". Try HELP.
>> Unknown command - "UNKNOWN". Try HELP.
>>
>> >> vertical? I know from my EV that the engine is on an angle and if the
>>
>> > Unknown command - "VERTICAL?". Try HELP.
>> Unknown command - "UNKNOWN". Try HELP.
>>
>> >> engine was designed to run upright, there is a very good chance of
>>
>> > Unknown command - "ENGINE". Try HELP.
>> Unknown command - "UNKNOWN". Try HELP.
>>
>> All subsequent commands have been flushed.
>>
>> Your message did not contain any command. Note that lines starting with a
>> "greater than" sign ('>') are ignored.
>>
>> Summary of resource utilization
>> -------------------------------
>> CPU time: 0.015 sec
>> Overhead CPU: 0.000 sec
>> CPU model: 2x90MHz Pentium (64M)
> --
> http://www.zstarr.com/impex
Your message did not contain any command. Note that lines starting with a
"greater than" sign ('>') are ignored.
Summary of resource utilization
-------------------------------
CPU time: 0.016 sec
Overhead CPU: 0.000 sec
CPU model: 2x90MHz Pentium (64M)
|