I am about ready to replace my non-functioning Viscous Coupling with a rebuilt unit. Have the Bentley manual, but it doesn't give any details of R & R ing the VC itself. Doesn't look like there are any difficult aspects, unless the input shaft is pressed into those dual bearings on the input side. Any BTDTs who can advise me? Thanks, Joel |
Please note - During the past 17 years of operation, several gigabytes of
Vanagon mail messages have been archived. Searching the entire collection
will take up to five minutes to complete. Please be patient!
Return to the archives @ gerry.vanagon.com
The vanagon mailing list archives are copyright (c) 1994-2011, and may not be reproduced without the express written permission of the list administrators. Posting messages to this mailing list grants a license to the mailing list administrators to reproduce the message in a compilation, either printed or electronic. All compilations will be not-for-profit, with any excess proceeds going to the Vanagon mailing list.
Any profits from list compilations go exclusively towards the management and operation of the Vanagon mailing list and vanagon mailing list web site.