Vanagon EuroVan
Previous messageNext messagePrevious in topicNext in topicPrevious by same authorNext by same authorPrevious page (December 1997)Back to main VANAGON pageJoin or leave VANAGON (or change settings)ReplyPost a new messageSearchProportional fontNon-proportional font
Date:         Mon, 1 Dec 1997 13:25:53 EST
Reply-To:     Jim Thompson <uvx196@JUNO.COM>
Sender:       Vanagon mailing list <Vanagon@Gerry.SDSC.EDU>
From:         Jim Thompson <uvx196@JUNO.COM>
Subject:      Re: 85 Digijet help request

To the list - It might be noted that Richard has replaced the idle stabilizer recently purchased new from me.

Richard - You might check to see if the throttle switches are functioning both mechanically and electrically. Located on the throttle body, these help tell the ECU when to idle and when to go to full enrichment at full throttle. Some later 85's, this was incorporrated as a single switch with dual contacts. 83.5 thru Early 85 had the two separate switches.

When not properly adjusted on their arms, the ECU can receive false signals. This was the case on my 84 Westy. Of course, check to make sure your harness connections are secure, clean and that there's continuity from the switches/airbox/aux air valve, etc., is making it to the ECU connector. There is a chance the ECU is the problem, but only a slim one at best in my experience. But then again I could be wrong.

Jim Thompson Check out our latest cool stuff at: http://www.oldvolkshome.com jim@oldvolkshome.com (530) 221-5342 Sherwood Automotive * The Old Volks Home

On Mon, 1 Dec 1997 09:33:28 -0800 Richard Angelini <richard@BALLY.COM> writes: >Any advice from you fellow listees on this would be appreciated TIA > >My 85 Westy with Digijet has the following problem; After driving at >60-65 for >awhile and then coming to a stop (clutch in) the engine dies. Or if >rather than >coming to a stop, slow down to say 20'ish the engine surges from 1200 >to 1600 >RPM (which causes the van to buck badly). If while surging I simply >push in >the clutch and stop/restart the engine the surging goes away. Sooo any >ideas??? > >I assume what is happening is that the ECU still thinks its at highway >speed >even after I slow down. This would explain why restarting the engine >while >rolling along clears the problem (the ECU gets reset). TIA for any >ideas!!! > >Richard 85 Westy - Reno NV >


Back to: Top of message | Previous page | Main VANAGON page

Please note - During the past 17 years of operation, several gigabytes of Vanagon mail messages have been archived. Searching the entire collection will take up to five minutes to complete. Please be patient!


Return to the archives @ gerry.vanagon.com


The vanagon mailing list archives are copyright (c) 1994-2011, and may not be reproduced without the express written permission of the list administrators. Posting messages to this mailing list grants a license to the mailing list administrators to reproduce the message in a compilation, either printed or electronic. All compilations will be not-for-profit, with any excess proceeds going to the Vanagon mailing list.

Any profits from list compilations go exclusively towards the management and operation of the Vanagon mailing list and vanagon mailing list web site.