Vanagon EuroVan
Previous messageNext messagePrevious in topicNext in topicPrevious by same authorNext by same authorPrevious page (December 1997)Back to main VANAGON pageJoin or leave VANAGON (or change settings)ReplyPost a new messageSearchProportional fontNon-proportional font
Date:         Thu, 11 Dec 1997 12:31:15 -0800
Reply-To:     "L-Soft list server at Vanagon List (1.8c)"
              <LISTSERV@GERRY.SDSC.EDU>
Sender:       Vanagon mailing list <Vanagon@Gerry.SDSC.EDU>
From:         "L-Soft list server at Vanagon List (1.8c)"
              <LISTSERV@GERRY.SDSC.EDU>
Subject:      Re: engine swap (ignorant questions) -> EV piston slap

>>> All Audi I-5 engines I've seen fitted to Audi 4K, 5K, 80, 90, 100, 200, >> Unknown command - "ALL". Try HELP.

> Unknown command - "UNKNOWN". Try HELP. Unknown command - "UNKNOWN". Try HELP.

>>> and VW Quantum are canted at approx 15-20 degrees. >> Unknown command - "AND". Try HELP.

> Unknown command - "UNKNOWN". Try HELP. Unknown command - "UNKNOWN". Try HELP.

>>> rb >> Unknown command - "RB". Try HELP.

> Unknown command - "UNKNOWN". Try HELP. Unknown command - "UNKNOWN". Try HELP.

>>> ---------------------------- >> Unknown command - "----------------------------". Try HELP.

> Unknown command - "UNKNOWN". Try HELP. Unknown command - "UNKNOWN". Try HELP.

>>> Scot wrote: >> Unknown command - "SCOT". Try HELP.

> Unknown command - "UNKNOWN". Try HELP. Unknown command - "UNKNOWN". Try HELP.

>>> I don't believe "Piston Slap" is HYPE, as it was claimed. I have a >> Unknown command - "I". Try HELP.

> Unknown command - "UNKNOWN". Try HELP. Unknown command - "UNKNOWN". Try HELP.

>>> question about the angle of the inline 5 as it is used in the Audi; do >> Unknown command - "QUESTION". Try HELP.

> Unknown command - "UNKNOWN". Try HELP. Unknown command - "UNKNOWN". Try HELP.

>>> the pistons travel vertically, or is there some angle set from >> Unknown command - "THE". Try HELP.

> Unknown command - "UNKNOWN". Try HELP. Unknown command - "UNKNOWN". Try HELP.

>>> vertical? I know from my EV that the engine is on an angle and if the >> Unknown command - "VERTICAL?". Try HELP.

> Unknown command - "UNKNOWN". Try HELP. Unknown command - "UNKNOWN". Try HELP.

>>> engine was designed to run upright, there is a very good chance of >> Unknown command - "ENGINE". Try HELP.

> Unknown command - "UNKNOWN". Try HELP. Unknown command - "UNKNOWN". Try HELP.

All subsequent commands have been flushed.

Your message did not contain any command. Note that lines starting with a "greater than" sign ('>') are ignored.

Summary of resource utilization ------------------------------- CPU time: 0.016 sec Overhead CPU: 0.000 sec CPU model: 2x90MHz Pentium (64M)


Back to: Top of message | Previous page | Main VANAGON page

Please note - During the past 17 years of operation, several gigabytes of Vanagon mail messages have been archived. Searching the entire collection will take up to five minutes to complete. Please be patient!


Return to the archives @ gerry.vanagon.com


The vanagon mailing list archives are copyright (c) 1994-2011, and may not be reproduced without the express written permission of the list administrators. Posting messages to this mailing list grants a license to the mailing list administrators to reproduce the message in a compilation, either printed or electronic. All compilations will be not-for-profit, with any excess proceeds going to the Vanagon mailing list.

Any profits from list compilations go exclusively towards the management and operation of the Vanagon mailing list and vanagon mailing list web site.