Date: Thu, 11 Dec 1997 09:58:39 -0800
Reply-To: "L-Soft list server at Vanagon List (1.8c)"
<LISTSERV@GERRY.SDSC.EDU>
Sender: Vanagon mailing list <Vanagon@Gerry.SDSC.EDU>
From: "L-Soft list server at Vanagon List (1.8c)"
<LISTSERV@GERRY.SDSC.EDU>
Subject: Re: engine swap (ignorant questions) -> EV piston slap
>> barwise@TUXEDO.ENET.DEC.COM wrote:
> Unknown command - "BARWISE@TUXEDO.ENET.DEC.COM". Try HELP.
Unknown command - "UNKNOWN". Try HELP.
>>>
>>> Well, you don't have to believe EV "piston slap", but is is a true,
>>> unfortunate occurance with some EV 5 cyl. motors, including mine.
>>> Afterall, they're not the *exact* same engine as used in the cars anyway,
>>> though they are very similar. There are many variations of I-5 engines
>>> in use. I only know of piston slap in the EV variation.
>>>
>>> I examined my 5 cyl. EV engine with its head off. I could actually wiggle
>>> 2 of the pistons in the block so you could hear them hit the side of the cyl.
>>> wall, and the bores had been worn out-of-round.
>>>
>> Chris Wrote this:
> Unknown command - "CHRIS". Try HELP.
Unknown command - "UNKNOWN". Try HELP.
>>> yes, they are all Audi 5 bangers.
>>> i think the "piston slap" thing is all HYPE yes.. HYPE
>> I don't believe "Piston Slap" is HYPE, as it was claimed. I have a
> Unknown command - "I". Try HELP.
Unknown command - "UNKNOWN". Try HELP.
>> question about the angle of the inline 5 as it is used in the Audi; do
> Unknown command - "QUESTION". Try HELP.
Unknown command - "UNKNOWN". Try HELP.
>> the pistons travel vertically, or is there some angle set from
> Unknown command - "THE". Try HELP.
Unknown command - "UNKNOWN". Try HELP.
>> vertical? I know from my EV that the engine is on an angle and if the
> Unknown command - "VERTICAL?". Try HELP.
Unknown command - "UNKNOWN". Try HELP.
>> engine was designed to run upright, there is a very good chance of
> Unknown command - "ENGINE". Try HELP.
Unknown command - "UNKNOWN". Try HELP.
>> piston slap.
> Unknown command - "PISTON". Try HELP.
Unknown command - "UNKNOWN". Try HELP.
>> How? For cylinders that run at an angle to vertical (at least on
> Unknown command - "HOW?". Try HELP.
Unknown command - "UNKNOWN". Try HELP.
>> Mitsubishi V6 engines), there is a piston pin offset that allows the
> Unknown command - "MITSUBISHI". Try HELP.
Unknown command - "UNKNOWN". Try HELP.
All subsequent commands have been flushed.
Your message did not contain any command. Note that lines starting with a
"greater than" sign ('>') are ignored.
Summary of resource utilization
-------------------------------
CPU time: 0.031 sec
Overhead CPU: 0.000 sec
CPU model: 2x90MHz Pentium (64M)