You are holding a shaft that fits into a 3-4 inch splined sleeve and this sleeve goes over another shaft, both shafts are held end to end by a 6mm stud screwed in the ends so...lots of slack up and down and around and almost nil in and our..the outboard end of the shaft is supported in the pilot bearing in the crankshaft..the one you *are* going to replace..yes? steve...... |
Please note - During the past 17 years of operation, several gigabytes of
Vanagon mail messages have been archived. Searching the entire collection
will take up to five minutes to complete. Please be patient!
Return to the archives @ gerry.vanagon.com
The vanagon mailing list archives are copyright (c) 1994-2011, and may not be reproduced without the express written permission of the list administrators. Posting messages to this mailing list grants a license to the mailing list administrators to reproduce the message in a compilation, either printed or electronic. All compilations will be not-for-profit, with any excess proceeds going to the Vanagon mailing list.
Any profits from list compilations go exclusively towards the management and operation of the Vanagon mailing list and vanagon mailing list web site.