Date:         Fri, 27 Feb 1998 22:13:33 EST
Reply-To:     NotaJeep <NotaJeep@AOL.COM>
Sender:       Vanagon Mailing List <Vanagon@vanagon.com>
From:         NotaJeep <NotaJeep@AOL.COM>
Subject:      Re: Transmission Question
Comments: To: vanagon@vanagon.com
Content-type: text/plain; charset=US-ASCII

You are holding a shaft that fits into a 3-4 inch splined sleeve and this
sleeve goes over another shaft, both shafts are held end to end by a 6mm stud
screwed in the ends so...lots of slack up and down and around and almost nil
in and our..the outboard end of the shaft is supported in the pilot bearing in
the crankshaft..the one you *are* going to replace..yes?

steve......

Please note - During the past 17 years of operation, several gigabytes of Vanagon mail messages have been archived. Searching the entire collection will take up to five minutes to complete. Please be patient!

Return to the archives @ gerry.vanagon.com

The vanagon mailing list archives are copyright (c) 1994-2011, and may not be reproduced without the express written permission of the list administrators. Posting messages to this mailing list grants a license to the mailing list administrators to reproduce the message in a compilation, either printed or electronic. All compilations will be not-for-profit, with any excess proceeds going to the Vanagon mailing list.

Any profits from list compilations go exclusively towards the management and operation of the Vanagon mailing list and vanagon mailing list web site.