Hello- I am trying to determine if it is possible to remove the clutch housing on a syncro tranny without removing the driveshafts (and thus marking the depth of axle flanges, I believe it was the axle flanges, and the like). I cannot really tell what is necessary from the bentley. I am hoping one would need to just remove the six bolts that hold the housing (bellhousing?) on to the tranny as it appears one needs to remove the clutch housing in order to replace the input main shaft... dave |
Please note - During the past 17 years of operation, several gigabytes of
Vanagon mail messages have been archived. Searching the entire collection
will take up to five minutes to complete. Please be patient!
Return to the archives @ gerry.vanagon.com
The vanagon mailing list archives are copyright (c) 1994-2011, and may not be reproduced without the express written permission of the list administrators. Posting messages to this mailing list grants a license to the mailing list administrators to reproduce the message in a compilation, either printed or electronic. All compilations will be not-for-profit, with any excess proceeds going to the Vanagon mailing list.
Any profits from list compilations go exclusively towards the management and operation of the Vanagon mailing list and vanagon mailing list web site.