Hi All, The head corrosion in wassers is the fault of the design, NOT of any particular aspect of coolant/maintanance etc. This is not to say that neglecting to change the coolant often enough is not part of the problem. The use of thick soft rubber gaskets in any corrosive enviroment is the source of the problem. Have a look at ANY alloy head and block in ANY car and I'll bet you will not find another fat rubber gasket. They are all thin/flat/highly compressed gaskets. The coolant is simply unable to get between the gasket and it's sealing face, unlike the VW wasserboxer. On our engines this leads to little pockets of trapped coolant, which go into overtime doing corrosion damage. The corrosion inhibitors in the coolant get depleted locally, and full galvanic corrosion sets in, in highly localized cells. The aluminium 'rust' takes up more space under the gaskets, lifting them off a bit and letting further seepage/pitting occur. Eventually it spans the seal face, and leaks, real fast once the pressurized coolant erodes the alum. oxide out of the way. Stiffening, aged rubber, and thermal contraction in cold weather, also help the corrosion further bye reducing clamping force over the gasket. Bad original design, plain and simple. The cure is a coating, VW tried cadmium, I doubt it lasts long since it is thin, and fretting wear due to micromotion will wear through it. Ceramics and epoxy work well.
<Soapbox ON> The reason we have so many little hoses/pipes/flanges joining the case sides, and to/from the water pump, is because this engine was not designed as a wasserboxer! We got a bandaid solution, not a new design. I LIKE German cars, respect their engineering and trust their reliability, (I've also had too many to dare admit otherwise) but the VW wasser was ill-conceived. At the risk of irritating folks (do I care?) go look at a Subaru engine. It has 2 large diameter rad oulets and 2 1/2" heater outlets. Everything else to do with the coolant is fully within the block. The heads are clamped down hard onto thin gaskets, using bolts into a block, not studs that rust out. They last 300K kms with only basic attention. This is how good design works. Do I want Subaru engines in my vans? yes, until I can get a VW-TDI in there. I just don't want a VW wasserboxer in an otherwise excellent vehicle, nor will I pay $$$$ to keep one there! And 95HP out of 2.1l is pathetic nowadays to boot. <pant, pant, end of rant> bye folks, Tim |
Please note - During the past 17 years of operation, several gigabytes of
Vanagon mail messages have been archived. Searching the entire collection
will take up to five minutes to complete. Please be patient!
Return to the archives @ gerry.vanagon.com
The vanagon mailing list archives are copyright (c) 1994-2011, and may not be reproduced without the express written permission of the list administrators. Posting messages to this mailing list grants a license to the mailing list administrators to reproduce the message in a compilation, either printed or electronic. All compilations will be not-for-profit, with any excess proceeds going to the Vanagon mailing list.
Any profits from list compilations go exclusively towards the management and operation of the Vanagon mailing list and vanagon mailing list web site.