Date:         Thu, 26 Mar 1998 18:25:15 -0800
Reply-To:     David Bayer <bayer@SYBASE.COM>
Sender:       Vanagon Mailing List <Vanagon@vanagon.com>
From:         David Bayer <bayer@SYBASE.COM>
Subject:      Cluch housing removal on a syncro
Comments: To: vanagon@vanagon.com

Hello-
        I am trying to determine if it is possible to remove the clutch
housing on a syncro tranny without removing the driveshafts (and thus marking
the depth of axle flanges, I believe it was the axle flanges, and the like).
I cannot really tell what is necessary from the bentley. I am hoping one
would need to just remove the six  bolts that hold the housing (bellhousing?)
on to the tranny as it appears one needs to remove the clutch housing in
order to replace the input main shaft...

dave

Please note - During the past 17 years of operation, several gigabytes of Vanagon mail messages have been archived. Searching the entire collection will take up to five minutes to complete. Please be patient!

Return to the archives @ gerry.vanagon.com

The vanagon mailing list archives are copyright (c) 1994-2011, and may not be reproduced without the express written permission of the list administrators. Posting messages to this mailing list grants a license to the mailing list administrators to reproduce the message in a compilation, either printed or electronic. All compilations will be not-for-profit, with any excess proceeds going to the Vanagon mailing list.

Any profits from list compilations go exclusively towards the management and operation of the Vanagon mailing list and vanagon mailing list web site.