Date:         Tue, 31 Mar 1998 13:16:08 -0800
Reply-To:     "Backus, Brian G" <Brian.Backus@PSS.BOEING.COM>
Sender:       Vanagon Mailing List <Vanagon@vanagon.com>
From:         "Backus, Brian G" <Brian.Backus@PSS.BOEING.COM>
Subject:      Re: J.B. Weld Head Repair
Comments: To: Vanagon@VANAGON.COM, WestyLuvr <WestyLuvr@AOL.COM>
Content-Type: text/plain

Here's another question...What did you all use for a straight egde to
assure a flat surface?
Brian G. Backus



> I applied the JB Weld to the pits.  I just used a sanding block to
> sand down
> the high spots even with the sealing surface of the head.  I think
> this is a
> great way to extend the life of the heads.
>
> Chris
> 86 Westy
>

Please note - During the past 17 years of operation, several gigabytes of Vanagon mail messages have been archived. Searching the entire collection will take up to five minutes to complete. Please be patient!

Return to the archives @ gerry.vanagon.com

The vanagon mailing list archives are copyright (c) 1994-2011, and may not be reproduced without the express written permission of the list administrators. Posting messages to this mailing list grants a license to the mailing list administrators to reproduce the message in a compilation, either printed or electronic. All compilations will be not-for-profit, with any excess proceeds going to the Vanagon mailing list.

Any profits from list compilations go exclusively towards the management and operation of the Vanagon mailing list and vanagon mailing list web site.