Years ago in a LeCar (LeWreck) I forgot to tighten some lug nuts. Well they only had 3 anyway. Wheel flew off but all was well, no crash, no major damage to LeWreck. After this I looked into the science of lug nuts and torque. Heres what I found: 1. Always use a torque wrench unless you are very experienced on judging torque's. Most of us are not. To little and the nut/bolt may loosen, Too much and the wheel/ rotor/ nut/bolt may be damaged. 2. It is the friction between the nut/bolt and wheel that holds the nut/bolt from loosening. But it is the friction of the threads on the nut/bolt that when corroded makes the nut/bolt hard or impossible to remove. The Best thing to do is to remove each nut/lug, clean all parts, and apply a small amount of some kind of protective lubricant to the threads. DO NOT USE MUCH, DO NOT GET ANY ON THE SEATING SURFACES OF THE NUT/BOLT/WHEEL.
If you do both these things the wheel will stay on when it should and it will be able to be removed when you want it removed. Even if some tire monkey with a Mega-Torque impact gun gets to the lugs the lack of corrosion on the threads will make it possible to get the nut/bolt off. |
Please note - During the past 17 years of operation, several gigabytes of
Vanagon mail messages have been archived. Searching the entire collection
will take up to five minutes to complete. Please be patient!
Return to the archives @ gerry.vanagon.com
The vanagon mailing list archives are copyright (c) 1994-2011, and may not be reproduced without the express written permission of the list administrators. Posting messages to this mailing list grants a license to the mailing list administrators to reproduce the message in a compilation, either printed or electronic. All compilations will be not-for-profit, with any excess proceeds going to the Vanagon mailing list.
Any profits from list compilations go exclusively towards the management and operation of the Vanagon mailing list and vanagon mailing list web site.