Vanagon EuroVan
Previous messageNext messagePrevious in topicNext in topicPrevious by same authorNext by same authorPrevious page (April 1998, week 4)Back to main VANAGON pageJoin or leave VANAGON (or change settings)ReplyPost a new messageSearchProportional fontNon-proportional font
Date:         Thu, 23 Apr 1998 09:45:35 -0500
Reply-To:     Darrell Boehler <dboehler@TAOS.MIDWEST.NET>
Sender:       Vanagon Mailing List <Vanagon@vanagon.com>
From:         Darrell Boehler <dboehler@TAOS.MIDWEST.NET>
Subject:      Re: Removing rear heater (Putting copper in coolant line)
Comments: To: Eric Brown <ebrown@ADOBE.COM>, Vanagon@VANAGON.COM
Content-Type: text/plain; charset="iso-8859-1"

------------------------- Eric, I recently replaced the radiator with a new german one on my 86 and it appeared to be copper. At the risk of dating my self many farm tractors had copper radiators in times past. Copper makes a great radiator now all we need is a good permanent way to bond plastic to it. A note on the rear heater if you use a pipe to connect the hoses together your front heater will loose most of its coolant circulation. The 2 heaters on my 86 are in parallel, and appeared to be stock that way. A good way to remove the rear heater and solve this problem would be to remove the Tees on the heater hoses and install a plain 5/8 inch coupling. I posted some information on my recent hose experience , many substitutions and have it posted at http://taos.midwest.net/vw .

Darrell Boehler Makanda Illinois

-----Original Message----- From: Eric Brown <ebrown@ADOBE.COM> To: Vanagon@VANAGON.COM <Vanagon@VANAGON.COM> Date: Wednesday, April 22, 1998 7:08 PM Subject: Removing rear heater (Putting copper in coolant line)

>The previous owner of my 87 Van found that the rear heater had a coolant >leak. So he removed it and didn't do a very good job gerry rigging the two >coolant hose connections together. So, I undid his gerry rigging and got a >standard piece of 3/4" copper hot water tubing and bent it into a U and >connected to two coolant hoses under the bench seat. (Before, the tubes were >connected straight on and were crimping thus allowing very little coolant to >flow.) > >Does anybody know if this copper is going to react in a very bad way with >the coolant or if there is a better way to solve my problem. I was told the >rear heater never puts out much heat in vanagons anyway. > >Thanks, >Eric >


Back to: Top of message | Previous page | Main VANAGON page

Please note - During the past 17 years of operation, several gigabytes of Vanagon mail messages have been archived. Searching the entire collection will take up to five minutes to complete. Please be patient!


Return to the archives @ gerry.vanagon.com


The vanagon mailing list archives are copyright (c) 1994-2011, and may not be reproduced without the express written permission of the list administrators. Posting messages to this mailing list grants a license to the mailing list administrators to reproduce the message in a compilation, either printed or electronic. All compilations will be not-for-profit, with any excess proceeds going to the Vanagon mailing list.

Any profits from list compilations go exclusively towards the management and operation of the Vanagon mailing list and vanagon mailing list web site.