In a message dated 98-05-04 18:11:42 EDT, bayer@SYBASE.COM writes: << I was hoping someone might tell me what blue printing is. From what I gather, it seems to be used when checking for straightness and maybe to verify that sealing surfaces are flat. I get the image of taking a part and pressing it on carbon paper or something similiar to make a print - is this close? >> It is actually kind-of slang. "Blueprinting" actually refers to putting the motor to ABSOLUTE specifications. During the normal manufacturing process, it is cost prohibitive to make the parts of the motor exactly as the "blue print" specifies. One cylinder may be a few cc's larger than another, one piston a tad heavier, the crankshaft journal for the #4 cylinder may be .005 degrees ahead of where it should be, etc. Regular machine shop work negates much of this, but usually seeks to bring part within a certain tollerance: e.g. "Pistons should weigh 145 grams, (+/- 3 grams)". "Blueprinting" brings it all to "ZERO" out of tollerance, e.g. "Pistons weigh 145 grams." By the weigh, (tee-hee) it is worth the extra $$$ usually about $200 to have the motor blueprinted. Smooth as silk. gmbulley cary, nc |
Please note - During the past 17 years of operation, several gigabytes of
Vanagon mail messages have been archived. Searching the entire collection
will take up to five minutes to complete. Please be patient!
Return to the archives @ gerry.vanagon.com
The vanagon mailing list archives are copyright (c) 1994-2011, and may not be reproduced without the express written permission of the list administrators. Posting messages to this mailing list grants a license to the mailing list administrators to reproduce the message in a compilation, either printed or electronic. All compilations will be not-for-profit, with any excess proceeds going to the Vanagon mailing list.
Any profits from list compilations go exclusively towards the management and operation of the Vanagon mailing list and vanagon mailing list web site.