Date:         Tue, 5 May 1998 13:27:20 -0700
Reply-To:     "Steven X. Schwenk" <sxs@SCHWENK-LAW.COM>
Sender:       Vanagon Mailing List <Vanagon@vanagon.com>
From:         "Steven X. Schwenk" <sxs@SCHWENK-LAW.COM>
Subject:      Re: Stupid Question- sliding door
Comments: To: Sam Scholten <vwvanagon@YAHOO.COM>
Comments: cc: Vanagon@VANAGON.COM
Content-Type: text/plain; charset=us-ascii

I may not be doing this right, but...I completely cleaned the lower
track area with wd40 and then formula 409...down to the paint.  I do not
put any grease on the track itself....a roller bearing just rolls along
there.  I used a good teflon lubricant on the bearings themselves...and
carefully wiped all extra lube away.

With this set-up, the lower track stays clean...no sand and grit
sticking to grease and turning into grime.  The door rolls smoothly.
The bearings need/get a shot of teflon lube about 3 times a year.  I
wipe the track down quickly with a paper towel and 409 several times a
year too.  I have maintained the door this way easily and without
problems for 4 years now.
 steve

Sam Scholten wrote:

> Volks,
>
> My sliding door has been stubborn for some time now on my '84. There
> is so much grime in there, I can't tell what kind of grease goes in
> there. The door is not binding; it is just really sluggish, and has
> been this way since I got the van. (it sat for awhile previously)
>
> So, what do I lube this beast with?
>
> Thanks in advance,
> Sam
>
> ==
> "Punk's not dead (it just sucks right now)"
>
> |                     "I'm not Punk, I'm New-Wave!"
>
> ...quit whining...
> http://www.geocities.com/SunsetStrip/Backstage/6507
>
> _________________________________________________________
> DO YOU YAHOO!?
> Get your free @yahoo.com address at http://mail.yahoo.com