Vanagon EuroVan
Previous messageNext messagePrevious in topicNext in topicPrevious by same authorNext by same authorPrevious page (May 1998, week 4)Back to main VANAGON pageJoin or leave VANAGON (or change settings)ReplyPost a new messageSearchProportional fontNon-proportional font
Date:         Fri, 22 May 1998 11:11:18 EDT
Reply-To:     VMontgo32 <VMontgo32@AOL.COM>
Sender:       Vanagon Mailing List <Vanagon@vanagon.com>
From:         VMontgo32 <VMontgo32@AOL.COM>
Subject:      Why does engine run cooler w/ heater on full-blast?
Comments: To: vanagon@vanagon.com
Content-type: text/plain; charset=US-ASCII

<< I've notice that I can get the coolant temp. needle to drop about a needle's width by cranking the heat to FULL. The needle will drop even a little further if I turn both fans on full. Why is this? >>

The heater core is acting as additional capacity for the radiator or cooling system. It is a "heat exchanger" as is the radiator.

I hope this answers your question.

Vic Montgomery


Back to: Top of message | Previous page | Main VANAGON page

Please note - During the past 17 years of operation, several gigabytes of Vanagon mail messages have been archived. Searching the entire collection will take up to five minutes to complete. Please be patient!


Return to the archives @ gerry.vanagon.com


The vanagon mailing list archives are copyright (c) 1994-2011, and may not be reproduced without the express written permission of the list administrators. Posting messages to this mailing list grants a license to the mailing list administrators to reproduce the message in a compilation, either printed or electronic. All compilations will be not-for-profit, with any excess proceeds going to the Vanagon mailing list.

Any profits from list compilations go exclusively towards the management and operation of the Vanagon mailing list and vanagon mailing list web site.