Date:         Sun, 31 May 1998 17:20:23 -0400
Reply-To:     Mark Rokus <marokus@VOYAGER.NET>
Sender:       Vanagon Mailing List <Vanagon@vanagon.com>
From:         Mark Rokus <marokus@VOYAGER.NET>
Subject:      Re: Syncro 3 groove pulley part #
Comments: To: David Bayer <bayer@SYBASE.COM>
Comments: cc: Vanagon@VANAGON.COM
Content-Type: text/plain; charset=us-ascii

David Bayer wrote:

> Underneath I found an elring seal (the same size
> and type as the new one in my engine gasket kit). Since there was supposed
> to be a horribly expensive seal under there, I am wondering if the two are
> interchangable. I was told by one shop that the Syncro 3 groove pulley has a
> different backing than the non syncro pulley

  My 2wd '84 has a 3 groove pulley and it used a standard seal.
Mark

Please note - During the past 17 years of operation, several gigabytes of Vanagon mail messages have been archived. Searching the entire collection will take up to five minutes to complete. Please be patient!

Return to the archives @ gerry.vanagon.com

The vanagon mailing list archives are copyright (c) 1994-2011, and may not be reproduced without the express written permission of the list administrators. Posting messages to this mailing list grants a license to the mailing list administrators to reproduce the message in a compilation, either printed or electronic. All compilations will be not-for-profit, with any excess proceeds going to the Vanagon mailing list.

Any profits from list compilations go exclusively towards the management and operation of the Vanagon mailing list and vanagon mailing list web site.