Joel Walker wrote: > > before you commit the ECU to the scrapheap, check the conductivity... Greetings, and still surging. Sorry I took so long to reply; I have been on a road trip up Vancouver Isl. Sales, and the van is my office. Thanks for the advice Joel, which I did try. I assume by conductivity you are referring to resistance in the wire. I tested the grounds for continuity. 0 ohms. Also the O2 sensor wire is clean too. Good connection there. Also tested the Gray wire from the coolant sensor to the ICM, via the main connector. The meter shows continuity, but there is .1 ohms of resistance showing which could be in the main connector of the FI harness where the 2 gray wires meet. Other problems are surfacing which I will post later. Thanks again. Randolph |
Please note - During the past 17 years of operation, several gigabytes of
Vanagon mail messages have been archived. Searching the entire collection
will take up to five minutes to complete. Please be patient!
Return to the archives @ gerry.vanagon.com
The vanagon mailing list archives are copyright (c) 1994-2011, and may not be reproduced without the express written permission of the list administrators. Posting messages to this mailing list grants a license to the mailing list administrators to reproduce the message in a compilation, either printed or electronic. All compilations will be not-for-profit, with any excess proceeds going to the Vanagon mailing list.
Any profits from list compilations go exclusively towards the management and operation of the Vanagon mailing list and vanagon mailing list web site.