Vanagon EuroVan
Previous messageNext messagePrevious in topicNext in topicPrevious by same authorNext by same authorPrevious page (June 1998, week 1)Back to main VANAGON pageJoin or leave VANAGON (or change settings)ReplyPost a new messageSearchProportional fontNon-proportional font
Date:         Fri, 5 Jun 1998 15:19:24 -0700
Reply-To:     Don Hundt <mtsupply@OUTLAWNET.COM>
Sender:       Vanagon Mailing List <Vanagon@vanagon.com>
From:         Don Hundt <mtsupply@OUTLAWNET.COM>
Subject:      Re: Removal of Vanagon Engine
Comments: To: Vanagon@VANAGON.COM
Content-Type: multipart/alternative;

In case it wasn't obvious in my previous post, the sawhorse goes inside the van, over the top of the engine.

Don Hundt wrote:

> when I removed my engine, rather than use a jack or engine crane, I > built a stout sawhorse out of 2 x 4s, attached a come-along to the > sawhorse and engine, raised the rear of the van and lowered it out the > bottom. better than balancing it on a jack. > Don > p.s.if anyone worried about the strength of my sawhorse, the 2 x 4s > are doubled into a t cross section on top, reinforced heavily on the > legs. a friend of mine also used it to remove an 800lb.+ detroit > diesel block from his school bus : ) > > Paul Borghese wrote: > >> Hi, Recently my 1985 Vanagon started idling rough (that is an >> understatement). I bought a compression tester and checked the >> cylinders. It turns out cylinder 4 has a compression of 75 while >> the others are >130. After dumping some oil into the spark plug >> hole, the compression jumped to 175 then slowly fell back down. So >> I want to remove the engine and take a look. Here is a few questions >> about the removal of the engine: 1. How heavy is the engine. Once >> I get it off the van, is it staying put? Or can I move it around? >> 2. What type of jack(s) should I use to remove the engine. I have >> a hydraulic jack with a 6 inch plate on top. Will that work or >> should I buy something else? 3. Once I remove the engine, does it >> take any special skill or expensive tools to rebuild an engine? Is >> it something I should be able to do with a copy of the Bentley >> Manual? Any ideas on where to buy replacement parts? Thanks, Paul >> Borghese > >


[text/html]


Back to: Top of message | Previous page | Main VANAGON page

Please note - During the past 17 years of operation, several gigabytes of Vanagon mail messages have been archived. Searching the entire collection will take up to five minutes to complete. Please be patient!


Return to the archives @ gerry.vanagon.com


The vanagon mailing list archives are copyright (c) 1994-2011, and may not be reproduced without the express written permission of the list administrators. Posting messages to this mailing list grants a license to the mailing list administrators to reproduce the message in a compilation, either printed or electronic. All compilations will be not-for-profit, with any excess proceeds going to the Vanagon mailing list.

Any profits from list compilations go exclusively towards the management and operation of the Vanagon mailing list and vanagon mailing list web site.