> IF you remove the hex head bolts on each side you will find > that they will recline to a perfect flat bed. Not a design, that > was by chance. What we need is somone to put there thinking cap > on and make a quick release set up to remove this bolt. > > Eric 86-VW4x4 > vw4x4@fyi.net 72-240z > Pittsburgh, PA USA 1936-Chrysler > maybe use rivets that have the same shaft dia. as the hex bolt, and drill a hole thru the tip of the rivet and put a cotter pin thru it? my $.02 worth Sudhir H. Desai 1984 VW Vanagon 3.4 liter Chevy V-6 cdes@welchlink.welch.jhu.edu 1996 Subaru Outback 2.2 liter flat-4 sudhir_desai@geocities.com 1997 Jeep Cherokee 4.0 liter I-6 |
Please note - During the past 17 years of operation, several gigabytes of
Vanagon mail messages have been archived. Searching the entire collection
will take up to five minutes to complete. Please be patient!
Return to the archives @ gerry.vanagon.com
The vanagon mailing list archives are copyright (c) 1994-2011, and may not be reproduced without the express written permission of the list administrators. Posting messages to this mailing list grants a license to the mailing list administrators to reproduce the message in a compilation, either printed or electronic. All compilations will be not-for-profit, with any excess proceeds going to the Vanagon mailing list.
Any profits from list compilations go exclusively towards the management and operation of the Vanagon mailing list and vanagon mailing list web site.