For get the VW part number.... Use a piece of heater hose. I think it was 3/4" i.d. that I used. You will have to mess around to get the right length and dia. ,,,,, This is known as back yard enginuity HeHeHE... Eric 86-VW4x4 vw4x4@fyi.net 72-240z Pittsburgh, PA USA 1936-Chrysler
On Sun, 14 Jun 1998, Don McCallum wrote: > Does anyone know if VW make a rubber dust cover for the diff lock > between where the shaft enters the housing and the servo unit - and if > so what the part number is? It looks like one is shown in the Bently > manual but I could not see it on the parts microfiche. I have just gone > to a lot of trouble freeing mine off and I would like to keep them well > protected! > > Don McCallum (1992 1.6 Turbo Diesel Syncro, North Wales, UK) > |
Please note - During the past 17 years of operation, several gigabytes of
Vanagon mail messages have been archived. Searching the entire collection
will take up to five minutes to complete. Please be patient!
Return to the archives @ gerry.vanagon.com
The vanagon mailing list archives are copyright (c) 1994-2011, and may not be reproduced without the express written permission of the list administrators. Posting messages to this mailing list grants a license to the mailing list administrators to reproduce the message in a compilation, either printed or electronic. All compilations will be not-for-profit, with any excess proceeds going to the Vanagon mailing list.
Any profits from list compilations go exclusively towards the management and operation of the Vanagon mailing list and vanagon mailing list web site.