Vanagon EuroVan
Previous messageNext messagePrevious in topicNext in topicPrevious by same authorNext by same authorPrevious page (June 1998, week 3)Back to main VANAGON pageJoin or leave VANAGON (or change settings)ReplyPost a new messageSearchProportional fontNon-proportional font
Date:         Thu, 18 Jun 1998 10:19:32 EDT
Reply-To:     GMBulley@AOL.COM
Sender:       Vanagon Mailing List <Vanagon@vanagon.com>
From:         GMBulley@AOL.COM
Subject:      Re: Hall sending unit/other electrical??? ('91)
Comments: To: nyquist@ACSU.BUFFALO.EDU, Vanagon@VANAGON.COM
Content-type: text/plain; charset=US-ASCII

Disclaimer for those who only want verifiable answers to VW questions: (This is completely a shot in the dark. A guess, based only on circumstances, and not personal experience with this SPECIFIC problem)

John--

Check the wiring diagram for conections between the ignition switch and the distributor, or associated circuits/relays. Since your ignition switch is new, it *may* not have all of its leads seated correctly, and one or more may be making only intermittant contact. This would explain the timing of the Hall sendor "failure" and the multiple keystrokes to start.

If this isn't the answer, yes, take it to the dealer. They will find the problem faster than you can say "Vanagon Carat Westfalia Synchro Deluxe, with hood scoop and curb feelers".

gmbulley cary, nc In a message dated 98-06-18 09:38:56 EDT, nyquist@ACSU.BUFFALO.EDU writes:

<< I recently posted this question about difficult starting of my 91 Vanagon. One out of 10-15 times the engine would crank about twice as long as normal before starting. My mechanic had found that the voltage in the Hall sending unit was dropping to about .2 volts when this happened but couldn't figure out why.

Well......, we replaced the Hall sending unit (new) and now the difficult start is almost a constant problem. It either cranks and starts when you turn the key or you have to crank it once, stop, then do it again - maybe 3 or 4 times before the engine will start. This isn't doing my new starter any good I'm sure! Ignition switch is new too.

So? Could the new Hall sending unit be faulty? Would it be the distributor? Possibly a computer problem? Can any of these be tested without replacing them? Should I go to the VW dealer (Aaaaaaarrghhhhhhhhhhhh)? >>


Back to: Top of message | Previous page | Main VANAGON page

Please note - During the past 17 years of operation, several gigabytes of Vanagon mail messages have been archived. Searching the entire collection will take up to five minutes to complete. Please be patient!


Return to the archives @ gerry.vanagon.com


The vanagon mailing list archives are copyright (c) 1994-2011, and may not be reproduced without the express written permission of the list administrators. Posting messages to this mailing list grants a license to the mailing list administrators to reproduce the message in a compilation, either printed or electronic. All compilations will be not-for-profit, with any excess proceeds going to the Vanagon mailing list.

Any profits from list compilations go exclusively towards the management and operation of the Vanagon mailing list and vanagon mailing list web site.