Vanagon EuroVan
Previous messageNext messagePrevious in topicNext in topicPrevious by same authorNext by same authorPrevious page (June 1998, week 5)Back to main VANAGON pageJoin or leave VANAGON (or change settings)ReplyPost a new messageSearchProportional fontNon-proportional font
Date:         Mon, 29 Jun 1998 09:32:18 -0600
Reply-To:     Fred Porter <fporter@EYRING.COM>
Sender:       Vanagon Mailing List <Vanagon@vanagon.com>
From:         Fred Porter <fporter@EYRING.COM>
Organization: EYRING, Corp.
Subject:      Re: Rear Brakes - How do you get JUST the drum off?
Comments: To: David Marshall <vanagon@VOLKSWAGEN.ORG>
Comments: cc: vanagon@vanagon.com
Content-Type: text/plain; charset=us-ascii

Dave, this is possible, i removed both my drums which has been on for thousands of mi.

i squirted liquid wrench in the bolt holes, the lug bolt holes and around the hole the hub passes through, had some beer and let the fluid work for a bit, then hammered the circumference of the drum with a rubber mallet and turned/pulled to get it off. it did require some force and a bit of time going between hammering and pulling and soaking more with liquid wrench.

BTW to replace the shoes, the killer tool tip is to get a spring grabber. the handle and shaft look like a screw driver, but the working end is a threaded cylinder with an angled slot. the cylider threads onto the shaft and by tightening you can clamp onto the brake springs. using pliers to work the brake springs is a PITA!

BTW2: i'd recommend checking your wheel cylinders while in there and also bleeding the entire brake system--i think brake fluid absorbs moisture and can cause corrosion--the fluid i bled was translucent brown, not clear.

later, fred

David Marshall wrote: > > I didn't mean to start another long and nasty thread here, but, I have seen > the rear drum removed from a Vanagon without removing the 500ft/lb nut the > holds the hub on. This is the way the VW dealer here does it all the time. > Yesterday I tried removing my drums and there is no way they would come > off. I removed the two bolts that "hold" it in place but the area around > the hub would not let go. I tried liquid wrench, wd 40, tapping it with a > hammer - no go... any suggestions here? I'd like to put new brakes on the > rear before heading to Saskatchewan on the 1st. > > Thanks in advance! > > -- David Marshall, Quesnel BC, mailto:david@volkswagen.org -- > -- 78 1.8L VW Rabbit, 80 2.0L VW Caddy, 87 Audi 5KQ -- > -- 85 1.8L VW Cabrio, 88 1.6L VW Syncro Double Cab -- > -- Volkswagen Homepage http://www.volkswagen.org -- > -- USE DAVID@VOLKSWAGEN.ORG WHEN SENDING PMAIL --


Back to: Top of message | Previous page | Main VANAGON page

Please note - During the past 17 years of operation, several gigabytes of Vanagon mail messages have been archived. Searching the entire collection will take up to five minutes to complete. Please be patient!


Return to the archives @ gerry.vanagon.com


The vanagon mailing list archives are copyright (c) 1994-2011, and may not be reproduced without the express written permission of the list administrators. Posting messages to this mailing list grants a license to the mailing list administrators to reproduce the message in a compilation, either printed or electronic. All compilations will be not-for-profit, with any excess proceeds going to the Vanagon mailing list.

Any profits from list compilations go exclusively towards the management and operation of the Vanagon mailing list and vanagon mailing list web site.